skip to main
|
skip to sidebar
Friday, August 12, 2011
Recent activity
Panel in with some temp seat foam.
Tail cone with micro
Fuel fill tube has good angle, I hope.
Fuel fill neck
Cabin heat box location
Oil tank neck extended
Car heat assembly
Canopy Lip Seal
West System micro added.
Looking good.
Added 2 layers to inside.
3 layers on the outside.
Duct tape prep
Pre lip smoothing of fuse.
Older Posts
Home
Subscribe to:
Posts (Atom)
Blog Archive
▼
2011
(3)
▼
August
(3)
Recent activity
Canopy Lip Seal
Oil Fill Door
►
2010
(4)
►
December
(1)
Notches will hold canopy open at different angles...
►
September
(1)
Fuselage Wiring
►
July
(1)
The wiring has begun! A stiffner for the pa...
►
February
(1)
Forward Progress
►
2009
(12)
►
July
(1)
Additions
►
June
(2)
Oil Seperator Attached to Engine
Firewall Forward
►
May
(2)
Center Console
Instrument Panel
►
April
(2)
Main tank mod for fuel probe
Carb Inlet
►
March
(4)
Mixture Cable Bracket
Oil Filter Adapter
Center Console Top
Side Reflexor Installation
►
February
(1)
Exhaust system
►
2008
(16)
►
December
(3)
Plenum creation
6-Pack rudder bell crank
Sitting in the Q200
►
November
(4)
Man power to install engine to check clearances. ...
Bent C antenna
Still Organizing
Q200 arrives in Florida 05Nov08
►
September
(9)
Old and new tailwheel comparison
Canard and wing root fairings
New cowling from Earnest
RH Wing tip
Changing Wheel Pants
Fuselage on firewall for bottom sand and fill plus...
Elevator ends glassed
Micro on Elevator
Wing prior to filling and root fillets.
Other Q200 websites links
http://www.quickiebuilders.org
http://www.quickheads.com