skip to main
|
skip to sidebar
Wednesday, December 17, 2008
6-Pack rudder bell crank
Done -removing foil and stipple.
Added some carbon fiber.
Prep for engine side glassing.
Over did the glass work.
Newer Post
Older Post
Home
Blog Archive
►
2011
(3)
►
August
(3)
Recent activity
Canopy Lip Seal
Oil Fill Door
►
2010
(4)
►
December
(1)
Notches will hold canopy open at different angles...
►
September
(1)
Fuselage Wiring
►
July
(1)
The wiring has begun! A stiffner for the pa...
►
February
(1)
Forward Progress
►
2009
(12)
►
July
(1)
Additions
►
June
(2)
Oil Seperator Attached to Engine
Firewall Forward
►
May
(2)
Center Console
Instrument Panel
►
April
(2)
Main tank mod for fuel probe
Carb Inlet
►
March
(4)
Mixture Cable Bracket
Oil Filter Adapter
Center Console Top
Side Reflexor Installation
►
February
(1)
Exhaust system
▼
2008
(16)
▼
December
(3)
Plenum creation
6-Pack rudder bell crank
Sitting in the Q200
►
November
(4)
Man power to install engine to check clearances. ...
Bent C antenna
Still Organizing
Q200 arrives in Florida 05Nov08
►
September
(9)
Old and new tailwheel comparison
Canard and wing root fairings
New cowling from Earnest
RH Wing tip
Changing Wheel Pants
Fuselage on firewall for bottom sand and fill plus...
Elevator ends glassed
Micro on Elevator
Wing prior to filling and root fillets.
Other Q200 websites links
http://www.quickiebuilders.org
http://www.quickheads.com
Done -removing foil and stipple.
Added some carbon fiber.
Prep for engine side glassing.
Over did the glass work.
